Even with slider over title, won’t turn yellow, cli says preamp and armstick issue ( stick not I’m safe position) I had it working and the nothing , motors calibrate fine, plz help

How heavy is your quadcopter, as 2205 motors should definitely make enough thrust to lift your quad… usually they make around 800g each of thrust?

Thx 4 ur help, Here’s the probkem, motors humming at full throttle on betaflight, but when props on still can’t get lift . I love this stuff but can’t fly

Just tried hover, no luck but noticed #4 motor sputters with slight delay b4 kicking in, other 3 appear to b doing their thing correctly think I should switch it out?

Not sure, lhi 220 build from kit, is motor a little off enuf 2 stop lift completely? What’s a good fpv goggle, not box about 150

[image] blackhawk: Just tried hover, no luck but noticed #4 motor sputters with slight delay b4 kicking in, other 3 appear to b doing their thing correctly think I should switch it out? I’m begining to think you have a bad motor or esc… Meaning one of your motors isn’t putting out enough thr…

I have fs-i6 controller, what’s a good fpv simulator forr practice

[image] blackhawk: good fpv simulator forr practice [image] The Best FPV Simulator to Practice Flying If you are just getting started with FPV, or a pro pilot having a good FPV simulator is never a bad thing. The main purpose of an FPV simulator is to help you practice flying or n…

So, I’m trying to connect vxt and camera. I connect vxt to 12v, then connect vxt signal wire to camera signal, can I splice red/black camera wires to servo lead connect it to 5v rail on fc board, will that work?

It depends on your camera some cameras want a higher voltage. What VTX do you have? Link What Camera do you have? Link What PDB do you have? Link What FC do you have? Link If you could show us a picture of where you intend to power the camera from that would help too.

F3 flight control board 6DOF standard; 700TVL camera; TS5728 FPV 5.8G 32check 600 mw transmitter, Matek PDB wxt60 connector. It is Lhi 220 quadcopter diy kit, thx

Can't arm quad in betaflight

Help

unmannedtech1 July 9, 2018, 9:23pm 55

Have you tried the driver fixer program here?

Topic		Replies	Views
Quadcopter not Arming? 🐝 How to Solve in BetaFlight Guides quadcopter , betaflight	2	3028	June 18, 2018
Drone wont arm , betaflight Help	27	2728	April 28, 2020
Drone not arming Help fpv , flightcontroller	1	2750	April 6, 2021
Problems with new drone Help	14	3779	March 10, 2019
Drone wont arm motors - betaflight FC MAMBA f405 MK2 Help betaflight , flightcontroller	1	1959	August 18, 2019

Can't arm quad in betaflight

Related topics