Yep…
1.Tested it when it came in,
2.then disconnected.
3.I applied the 6 motor wires to the pdb and fc
4. I connected normaly and i was in the fc settings as normal,
But then the motors didnt work, so i looked it up Google. There someone said that i needed to put a code in the “cli” so i did that…
After that when i disconnected it, it would just not turn on anymore, the lights dind’t blink and the lights dindt light up anymore,
Yeah i know its probably my fault, but there might be a way to fix it, i hope 
Thnx -tim