Didnt actually thinking about that, but thats a good point as probably if it didn’t stick out will probably be in view…But 1mm is hardly an issue.
Brilliant idea. Did you think to make one piece angle tpu case with zip tie mount too drone ? Something like session mount ?
I did.
But I wanted something that could be easily moved from frame to frame.
Without having to unscrew any screws from the mount or cut zip ties.
Using normal fitted GoPro mounts just makes it that little bit easier.
That way everyone can use there favorite mounts and mount them how they like and just slot in the camera.
Version 1 on the box mount did work… But I was a little worried about heat.
So as a “Engineering Solution” I drilled holes into the box to let air in…
Then started work on v2 of the Box…
Lots more air flow
You can insert and remove the SD card and access the push button on the side still.
Nice, just gotta think of a cool name for it… GoTurtle Session
I am following your project, looks super promising. do you have a final desing?
Have you thought of giving the design some GoPro style mounting features? It could give some flexible mounting locations if the normal mounting space for an fpv cam is taken
I use a GoPro, and designed this mount for it
I guess thats the entire reason why @DoomedFPV designed it as a gopro session form factor , but yeah received it in the post yesterday but didnt get a chance to properly look at it yet so thats on my list today
Just need a space for a small lipo too then will be a modular gopro session replacement! But otherwise can just use teh balance plug to attach an external battery.
for me with the balance plug for power it´s enough modular. Please keep us inform! thanks
any progress? date? my quads are waiting
@DoomedFPV finished the design and the prints are done so should be added to our store next week
I will update this post with a link
Say hello to my little friend…
Its out… Its out and in the store
- The case has a button on the side so that the turtle button can be used.
- LED through holes to see the record light on the turtle.
- A flap over the SD card slot to help protect against SD card ejections.
- A slot for a 5 Pin JST connector to make swapping the case between build easier.
The camera screws in from each side of the case holding it closed and the HD board just slots in
the gap. Its a snug fit and keeps any movement down to a minimum.
Ordered mine! I will post a review with the performance and results! thanks for development this kind of products
Thanks for buying one.
Let us know how you get on an if you have any suggestions.
Feel free to write you finding here so everyone can read them.
Now I don’t normally link my YouTube videos here… but seen as this one is flight footage from the Caddx turtle mounted in the DIY Box in a GoPro mount.
I’ll link it.
No post processing done on the footage or color correction.
The crash at 1:49 made me go back and watch again as first thought it was an impressive recovery
Nice flying and footage
So…
With Matek bring out a new FC.
Matek F722-SE AIO Flight Controller
That supports dual camera control.
I’m going to strip down my Caddx box and wire up the video and TX & RX pads from the Caddex to the 5pin JST connector.
With the new FC I’ll be able to switch to the Caddx, activiate the HD record via a switch on my Transmitter and then switch back to my FPV camera.
I’ll add a couple of picture below and a wiring diagram as I go.