Hello,
Actually I think I figured it out. Changed Mode settings to CPPM, then, assigned a switch on my Taranis for Ch 6, then went to receiver sliders, and viola! I have output!
Now… all that done, and my strobes do not come on.
But, I think I have it. I just need to do some wire crimping, as I think it is a ground problem. I have a step down converter at 11.1 Volts, stepped down to 3.6V that I plan on using to power the output rail via the Ch8 pins for the strobes. (Ch1-8 no power output from board)
Then, I am going to just simply plug everything into the output rail on Ch6. That is, the signal wire that comes from my flytron strobe controllers, the power wire going IN to the strobe controller, and the ground.
That should do it.
Thanks
Ted