I am currently away from my home but from memory when I turn on the drone I have a blinking red light, I believe I also had a green light on a different board as well but I can’t remember if that was because I had cleanflight hooked up too, anyway If I had to guess at the speed its less than a second (one thousand 1), probably half a second, when I turn on the receiver the red light goes steady. I have the Eachine I6 receiver that came with the Falcon 250 Pro.
Once I get home I will confirm these details but I believe I am correct in my memory. As I have stated before when I move the roll or yaw stick the LED’s on the drone reflect those movements, but that is about all I can get the drone to do.
to answer the other post as well I have moved the FC to port 2 to allow power up while connected to CleanFlight or BetaFlight but that changed nothing on the arming issues… all 4 motors start at 1060 on motor test.
I cannot thank you all enough for helping me out on this