Slim BGC joystick setup help

[Scott]

I have purchased a Slim BGC controller like this:

Slim BGC Assembly Guide

I can’t work out if that is possible to connect a menu button or a joystick control. I’m assuming the 6 pin header pad is for programming the bootloader - but I could be wrong? Does anyone have any details for this board?

thanks, Scott

[unmannedtech1]

You need to connect the gimbal to the analogue inputs on the board, they are labeled A1, A2 etc…

Adding a Joystick to your Alexmos Brushless Gimbal Controller

The best way to maunally control a handheld brushless gimbal is to add a joystick module. This allows you to adjust the pitch and roll angles manually to keep your subject in the shot. This works in the same way as adding an RC receiver to the controller to control the pitch/roll angles remotely. To do this you will just need to buy a Gimbal Director module and connect it to your brushless gimbal controller as shown below. As shown in the diagram you will need to connect the cables to the RC…

[Scott]

Thanks for the reply but I don’t have that connector on my board - I have the ‘Slim’ controller in the link I posted.
I do have an RC input connector and these pins are labeled GND, 5V, A0, A1, A2, A3. But I think they are the RC_ROLL, FC_PITCH, RX_ROLL, RX_PITCH pins.